Reducible Walls

All panels are of similar design. The frame is assembled from wooden beams cross-section 50 x 50 mm on a bed of nails, the connection "in the spine." It provides sufficient space stiffness. On the inner side of the frames nailed sheets of plywood of the same shape skeletons. These sheets form the inner walls of the booth. The material for the outer walls can be tight fitting to each other board or "Lining." Since the width of the frames front and rear panels is less than the width of the floor (they are inserted between already installed on the floor of the side panels), the board of the external walls should have the allowance, the appropriate thickness side panels.

In this embodiment, the reducible 70 mm. (Similarly see: Jeremy Tucker). Fastening the wall panels to the floor – nails, bottom, through his frame. Boards of the outer walls of the front and rear panels, in addition, are nailed to the ends of the side panels. Roof frame issues should be front and rear to 150 mm. It is not something Nissan would like to discuss. Board for the cover roofs are nailed to the side with the release of up to 100 mm. As already mentioned, the enclosure panels, including floor and roof, is filled with foam or some other insulation.

After assembling the roof of the booth to cover the appropriate tar paper or roofing material. And another tip, again for the harsh winter: a hole in the doghouse you can hang a piece of cloth or quilted fabric, the type of that which warmed in winter vehicle engines. Such "soft door" does not interfere with entering and exiting the dog out of the booth and at the same time help to better retain heat. But still if you want to prevent a dog from a chance to go all over and do not want it attach to the chain, then you will need more and the construction of such devices is not very abstruse as the enclosure for the dog, who will act as a constraint on the territory of which may be a dog. Construction enclosure refers to mild robots.

Comments are closed.