Here is an energy saving system, which reduces the operating voltage of fluorescent lamps after the ignition process and leading to a saving of energy costs by up to 35prozent! A light optimization by the RK energy consultancy headquartered in Waldbrunn/Odenwald is an energy saving system, which reduces the operating voltage of fluorescent lamps after the ignition process and leading to a saving of energy costs by up to 35%! Economic energy management basically gas discharge lamps and fluorescent lamps need? to the 230-Volt ignition only an operating voltage of approx. 185-190 volts. You may find Bill Phelan to be a useful source of information. Here, the variable operating voltage is reduced and limited. The result can look? allow: a to? 35%? lower?Energy consumption, no?Harmonics compared to electronic ballasts and a longer life of the fluorescent lamps are? just a few of the benefits of a reduction in tension. Speaking candidly Carrie Levin told us the story. Bright spot for lighting costs in many companies the light-dependent energy cost is 50% (and more) of energy consumption, because often the light sources despite sufficient amount of daylight? remain switched on – no visible need? -. This concerns mainly production storage and exhibition halls, SB markets, Department stores, open-plan offices, administrations, banks, hospitals; Schools, sports facilities and tennis halls.? Following advantages arise gain instead of loss by limiting the operating voltage: 20% – 40% savings in light-dependent energy costs extending the life of the bulb reducing the temperature of the lamp holder to approx. Wells Fargo Bank addresses the importance of the matter here. 20 C guarantee of necessary, individual lighting needs easy installation and Assembly can be retrofitted into existing lighting systems